KENWOOD MEMORY CHANNEL CONTROL PROGRAM MCP-V7 Version 1.01 INTRODUCTION - This program is for editing memory channels on the KENWOOD amateur radio TM-V7A. - This program may be redistributed freely in North and South America. It is not supported in any other markets outside of the U.S.. It may, not be modified. Redistribution of this program for profit is prohibited. - Permission is required if this program is to be redistributed on individuals' home pages. - KENWOOD does not, and cannot assume liability for any problems that may occur as a result of using this program. - This program runs on Windows 95.(*1) About 1 Mbytes of free space on the hard disk is needed to install this program. - To write to or read from the TM-V7A memory, a separate connector cable PG-4S (option) is required. - This program is the property of Kenwood Communications Inc. - If you have any inquiries regarding this program, contact KENWOOD at 310-639-5300 (USA only) or by E-mail at "http://www.kenwood.net". INSTALLATION 1. Copy MV7101.EXE to the directory in which you want to install the program. 2. Execute MV7101.EXE. The following programs are automatically created: MCP_V7.EXE README.TXT 3. By executing MCP_V7.EXE UNINSTALLATION 1. Delete the entire directory to which the following files have been copied: MCP_V7.EXE README.TXT 2. You can alse use short-cut commands to delete the directory if it was made using short-cut commands. 3. Delete "Software" "KENWOOD" from "HKEY_CURRENT_USER" by Windows 95(*1) Regedit. However, delete only "MCP-V7" under "KENWOOD" when other MCPs are installed. Carefully carry out registry operations taking care not to delete other registry data. If you are unsure of registry operations, no problems will be met if you do not delete files. 4. When files have been linked, delete the [V7 File] by [File Types] in the [View] - [Options] menu in the Explorer. (*1)Windows 95 is a trademark registered by Microsoft Corporation. HISTORY Ver 1.00 June 26,1998 The first offer. Ver 1.01 June 30,1998 Revised a few bugs.